D-Link DXS-3400 User Manual - Page 231

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide Figure 6-33RIPng Interface Settings Window The fields that can be configured are described below: Parameter Interface VLAN State Metric Offset BFD State Passive Interface Description Enter the VLAN interface's ID here. The range is from 1 to 4094. Tick the All Interface check box to configure all interfaces. Select to enable or disable the IPv6 RIP feature on the VLAN interface specified. Enter the value to be added to the metric of an IPv6 RIP route received on the configured interface here. The range is from 1 to 16.The metric refers to the hop count. By default, when receiving an IPv6 RIP route, a metric value of 1 is added to the route before it is inserted into the routing table. Use this option to influence the metric of routes received on different interfaces and thus influence the preference of the route. Select the Default option to use the default metric offset value, which is 1. Select to enable or disable the BFD state. Select to enable or disable the passive interface feature here. If this option is enabled, the router will not send RIPng packets out through the interface. However, RIPng packets from other routers received on the interface will continue to be processed. Click the Apply button to accept the changes made. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. RIPng Database This window is used to display the RIPng feature's routing database. To view the following window, click L3 Features> RIPng >RIPng Database, as shown below: Figure 6-34RIPng Database Window The fields that can be configured are described below: Parameter Description IPv6 Address/Prefix Length Enter the IPv6 address that will be used for this display here. Click the Find button to locate a specific entry based on the information entered. 221