D-Link DXS-3400 User Manual - Page 432

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter Unit From Port ~ To Port Instance Receiver Interval Description Select the Switch unit that will be used for this configuration here. Select the appropriate port range used for the configuration here. Enter the instance's index number if multiple samplers are associated with one interface. The valid range is from 1 to 65535. Enter the receiver's index value for this poller here. This value must be between 1 and 4. Enter the maximum number of seconds between successive polling samples. This value must be between 0 and 120 seconds. Entering 0 will disable this feature. By default this value is 0. Click the Apply button to accept the changes made. Click the Delete button to remove the specified entry. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. Device Environment The device environment feature displays the Switchinternal temperature status. To view the following window, click Monitoring>Device Environment, as shown below: Figure 11-22Device Environment Window External Alarm Settings This window is used to display and configure the external alarm settings. This is used to enable monitoring the external alarm source status or to configure external alarm message for a channel.The source of alarm is located outside of the Switch and is monitored via pre-defined connecting channels. Each channel represents a specific alarm event. The status of an alarm source can be either in the alarm state or in the normal state. If the source is absent or the source is present and in the normal state, the status will be normal. The status will be abnormal if the source is in the abnormal state. A notification will be sent when the monitoring status is changed. To view the following window, click Monitoring>External Alarm Settings, as shown below: 422