HP 4600 Service Manual - Page 237

CAUTION Always place the spacer under the chassis. This spacer supports the printer and keeps it from flexing when the plate that covers the laser/scanner units is removed. If the chassis flexes, the laser beams can become skewed, resulting in print-quality problems. 6 Remove four screws (callout 4). Figure 6-52 Remove the laser/scanner cover plate (1 of 2) 7 Using needle-nose pliers, pull down on the right side of the wire clip, then release the left side of the clip from the bracket. Repeat this step for each of the four clips. 8 Remove the plate that covers the laser/scanner units. Figure 6-53 Remove the laser/scanner cover plate (2 of 2) Reinstallation tip When reinserting the four wire clips, insert the left end of the clip first, thread the clip under the center notch, and then insert the right end of the clip. ENWW Internal components 221