HP 4600 Service Manual - Page 292

Table 7-2 Alphabetical printer messages (HP Color LaserJet 4600 models) (continued) Message Description Action Rotating. . . transfer motors The printer is executing a Component test and the Transfer Motors component is selected. Press CANCEL JOB when you want to stop this test. To exit press CANCEL JOB SIZE MISMATCH TRAY xx= For help press alternates with Ready The tray is loaded with media that is longer or shorter in the feed direction than the size that is configured for the tray. 1 Adjust the side and rear guides against the media. 2 If the media used is Letter, A4, Executive, B5 JIS, A5, or Legal size, the tray switch should be set to STANDARD. Set the tray switch to CUSTOM for all other media sizes. The tray switch must be set before the size can be selected from the control panel. For menus press 3 Reset the paper size in the paperhandling menu. TRAY xx CONTAINS UNKNOWN MEDIA The media type in the specified tray cannot be determined. 1 To change the media type, press . Use and to highlight the type, and then press to select. 2 To change the media size to Letter, A4, Executive, B5 JIS, A5, or Legal, leave the tray switch in the STANDARD position. 3 To change the media size to other sizes, move the tray switch to CUSTOM, adjust the guides against the media, and close the tray. 4 Use and to highlight the media size, and then press to select. TRAY xx EMPTY The specified tray is empty and needs to be filled, but the current job does not need this tray to print correctly. Refill the tray at a convenient time. alternates with Ready For menus press TRAY xx OPEN For help press alternates with The specified tray is open or is not closed completely. Close the tray. 276 Chapter 7 Troubleshooting ENWW