HP 4600 Service Manual - Page 392

System setup menu The System setup menu allows you to make changes to general printer configuration default settings such as PowerSave Time, printer personality (language), and jam recovery. Table 7-44 System setup submenu Menu item JOB STORAGE LIMIT Values 1 to 100 JOB HELD TIMEOUT SHOW ADDRESS (HP Color LaserJet 4650 models) OFF 1 HOUR 4 HOURS 1 DAY 1 WEEK AUTO OFF COLOR/BLACK MIX = AUTO MOSTLY COLOR PAGES MOSTLY BLACK PAGES Description Sets the limit for the maximum number of jobs that can be stored on the hard disk at the printer. Sets the period of time that the system keeps files in job storage before deleting them from the queue. This item determines whether the printer's IP address is shown on the display with the Ready message. If more than one EIO card is installed, the IP address of the card in the first slot is shown. The default is off. This menu item establishes how the printer switches from color to monochrome (black and white) mode for maximum performance and print cartridge life. AUTO will determine the mode the engine will enter based on the first page of a print job. If the first page is monochrome, the engine will enter mono mode until a color page is detected. It will then continue in color mode until the end of the job. If the first page is in color, the engine will enter color mode for the duration of the job. Select MOSTLY COLOR PAGES if nearly all of your print jobs are color with high page coverage. This will cause the engine to always run in color mode, even if the whole job is in monochrome. Select MOSTLY BLACK PAGES if you print mostly monochrome print jobs, or a combination of color and monochrome print jobs. This will cause the engine to switch back and forth between color and monochrome mode. If the first page is monochrome, the engine will enter mono mode until a color page is detected. It will then enter color mode. If 3 consecutive monochrome pages are detected, the 376 Chapter 7 Troubleshooting ENWW