HP 4600 Service Manual - Page 333

Table 7-5 Numerical printer messages (HP Color LaserJet 4610n and 4650 models) (continued) Message Description Action 40 EIO X BAD TRANSMISSION To continue press A connection with the card in 1 Press to resume EIO slot X has been broken printing (see note below). abnormally. 2 Check that all cables are connected to the EIO ports and that the EIO board is seated properly. 3 If possible, print to another network printer to verify the network is working properly. NOTE A loss of data will occur. 41.3 UNEXPECTED SIZE IN TRAY XX For help press alternates with The media that is loaded is 1 If the incorrect size was longer or shorter in the feed selected, cancel the job direction than the size that is configured for the tray. or press for more information. 2 Press and to step through the instructions. LOAD TRAY XX: [TYPE] [SIZE] To use another tray press 41.5 UNEXPECTED TYPE IN TRAY X For help press alternates with The printer senses a 1 If the incorrect type was different media type in the selected, cancel the job media path than the type that is configured in the tray. or press for more information. 2 Press and to step through the instructions. LOAD TRAY XX: [TYPE] [SIZE] To use another tray press 41.X PRINTER ERROR For help press alternates with A printer error has occurred. 1 Press to continue or X Description press for more information. 1 unknown misprint error 2 If the message persists, 2 beam detect misprint error turn the printer off and then on. 3 media feed error (size) ENWW Printer-error troubleshooting 317