HP Workstation x2000 hp workstation x2000 - Technical Reference and Troublesho - Page 153
Removing and Replacing the Cover and, Front Bezel
View all HP Workstation x2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
Installing and Replacing Hardware Parts Removing and Replacing the Cover and Front Bezel Figure 6-2 HP x2000 Workstation System Board Up to six accessory cards can be installed: • One AGP PRO 4X slot (graphics) Memory module sockets supporting four RDRAM modules • Five 32-bit Workstation slots Processor (heatsink not shown) Secondary IDE Connector Primary IDE Connector Floppy Disk Drive Connector WARNING Removing and Replacing the Cover and Front Bezel For your safety, never remove the Workstation cover without first disconnecting the power cord from the power outlet and removing any connection to a telecommunications network. If a Power Protection Device is fitted to your Workstation, you must shut down your computer using its on/off switch, then remove its power cord before removing the Workstation's cover. Remove the Power Protection Device cables before any servicing operation. Always replace the cover before switching the Workstation on again. Chapter 6 153