HP Workstation x2000 hp workstation x2000 - Technical Reference and Troublesho - Page 89
Clearing the CMOS
View all HP Workstation x2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
HP BIOS Clearing the CMOS Clearing the CMOS 1. Turn off the Workstation, disconnect the power cord and all cables, then remove the cover. 2. Set the system board switch 8 to ON. 3. Replace the cover, and reconnect the power cord and video cable. 4. Reboot the Workstation. A message similar to the following will appear: "Configuration has been cleared, set switch Clear to the ON position before rebooting." 5. Turn off the Workstation, disconnect the power cord and video cable, and remove the cover. 6. Set the system board switch 8 to OFF. 7. Replace the cover, and reconnect the power cord and data cables. 8. Turn on the Workstation. Press F2 to run Setup, then press F9. The system automatically downloads and saves the CMOS default values. 9. To save the configuration and exit Setup, press Esc . Chapter 3 89