HP Workstation x2000 hp workstation x2000 - Technical Reference and Troublesho - Page 171

NOTE Installing and Replacing Hardware Parts Installing a Second Hard Disk Drive in an Internal Shelf Installing a Second Hard Disk Drive in an Internal Shelf The internal hard disk shelves, located just under the floppy drive, can support two 3.5-inch devices. To install a second hard disk drive: 1. Switch off the display and Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2. Remove the Workstation's cover (refer to page 153 for instructions). 3. If the boot IDE hard disk drive is installed in the lower shelf, disconnect the data and power cables. Move the boot drive to the upper shelf and install the secondary drive in the now empty lower shelf. This is not necessary if the drive is a SCSI drive. 4. Attach the blue rails (found on the CD cage) to the new hard disk drive. Insert the guide rail labeled "L" on the left-hand side (cable connectors facing towards you and positioned at the bottom), and the guide rail "R" on the right-hand side of the hard disk drive. 5. You can insert the second hard disk drive only one way. Make sure the data and cable connectors are facing you and positioned at the top. 6. Align the guide rails on both sides of the drive with the internal shelf guides and then slide the drive into the bottom shelf until it clicks into position. Avoid trapping or disconnecting the hard disk drive bay thermal sensor cable. If this cable becomes disconnected, reconnect it to the system board connector labeled THERMAL_SENSOR (positioned near the IDE and Floppy data cable connectors. 7. Connect the power and data cables to the second hard disk drive. Reconnect the power cables and the data cable to the boot hard disk drive. 8. Replace the Workstation's cover (refer to page 153). Reconnect all the power and telecommunications cables. Chapter 6 171