HP Workstation x2000 hp workstation x2000 - Technical Reference and Troublesho - Page 165

Installing and Replacing Hardware Parts Mass Storage and Optical Device Overview Figure 6-8 16-bit SCSI Terminator fitted on cable Cables and Connectors (SCSI Models) Secondary IDE cable Two IDE data cables each with two 40-pin connectors for IDE Drives 16-bit Internal U160 68-pin SCSI connector 16-bit SCSI cable with three 68-pin connectors Primary IDE cable External 68-pin SCSI connector accessible from the rear of the Workstation SCSI Card in WorkstationI Slot Secondary IDE Connector Cable with one 34-pin connector for 3.5-inch Floppy Disk Drive Floppy Disk Drive Connector Primary IDE Connector NOTE The total length of the external SCSI cables should not exceed 3 meters (approximately 10 feet). Before Installing a SCSI Hard Disk If you are installing an additional SCSI drive, you should assign an unused SCSI ID to this accessory. SCSI IDs range from 0 to 15 for wide 16-bit SCSI. SCSI ID 0 is used by the first SCSI hard disk drive and SCSI ID 7 is reserved for the integrated SCSI controller (the default for narrow and wide SCSI devices). You should assign an unused SCSI ID to the second SCSI hard disk drive Chapter 6 165