HP Workstation x2000 hp workstation x2000 - Technical Reference and Troublesho - Page 156
Removing and Replacing the Cover and Front Bezel,
View all HP Workstation x2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
Installing and Replacing Hardware Parts Removing and Replacing the Cover and Front Bezel plastic tabs with their slots on the right-hand side of the chassis, and then close the bezel. After closing the bezel, confirm that the tabs on the left side are fully seated flat against the chassis. 3. Standing at the back of the Workstation, lower the cover onto the chassis (aligning the guide rail on the bottom inside edge of the cover with the bottom edge of the Workstation chassis). 4. Shut the cover ensuring that the guides on the top of the cover slide into the rails at the top of the chassis. 5. Slide the cover forward, then tighten the two thumbscrews. 6. If required, lock the cover using the key provided. Reconnect all the power and telecommunications cables. 156 Chapter 6