HP Workstation x2000 hp workstation x2000 - Technical Reference and Troublesho - Page 190

Installing and Replacing Hardware Parts Replacing the Fan and Speaker Assembly Replacing the Fan and Speaker Assembly Removing the Fan and Speaker Assembly 1. Switch off the display and Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2. Remove the Workstation's cover and front upper and lower bezels. Refer to page 153 for these instructions. 3. Disconnect the cables from their connectors located on the system board. 4. For ease of installation, place the Workstation on its side with the system board facing upwards. 5. Remove the Workstation chassis beam. 6. Remove the screw from the front of the chassis. 7. Unclip the three clips on the front of the chassis. 8. Slide the fan and speaker assembly towards the rear of the Workstation until it is clear of the chassis, then remove it from the Workstation. Replacing the Fan and Speaker Assembly 1. Place the fan and speaker assembly behind the internal shelves (the speaker should be near the bottom edge of the chassis and facing towards the front of the Workstation). Ensure all cables are clear of the assembly, then carefully move the fan and speaker assembly towards the front of the chassis. 2. Align the clips and guide pins with their appropriate sockets and slide the assembly forward to secure it into place. 190 Chapter 6