HP Workstation x2000 hp workstation x2000 - Technical Reference and Troublesho - Page 219

Troubleshooting Your x2000 Workstation Use or Configuration Problems Check that... How... The port is correctly configured in the Setup program. 1. Switch the Workstation OFF then ON. 2. When the message Press F2 to Enter Setup appears, press the F2 key. 3. Check the port is enabled and the correct setting is selected under Integrated I/O Ports in the Advanced menu. Restore the default settings in the Setup program. 1. When the message Press F2 to Enter Setup appears, press the F2 key. 2. Press the F9 key to restore the default settings. All connected devices are correctly connected and switched on. 1. Plug the cables into the correct connectors on the Workstation rear panel. 2. Switch on the Workstation and the external devices. The correct device drivers are installed. Refer to the device documentation. If the Workstation still has a problem... You may need to update the Basic Input Output System (BIOS). Create a bootable floppy to update the BIOS. Refer to page 225. Check that... How... The system board is working. 1. Replace the system board by a known working board from the same model of Workstation. 2. Close the Workstation, reconnect the power cord and check that the Workstation works. 3. If the port works, contact HP Support or your authorized dealer for further troubleshooting information. If the problem persists, contact HP Support or your authorized dealer. An Error Message Appears on the MaxiLife LCD During Runtime During normal usage (and at boot) of the Workstation, MaxiLife continually monitors vital system parameters. These include: Chapter 7 219