Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 10

ProSafe Managed Switch Command Group or Command M5300-28G-POE+ M5300-28G M5300-52G-POE+ M5300-52G IPv6 MLD-Proxy Commands Require license PoE Commands Supported MVR Commands Supported Link Local Protocol Filtering Supported Commands Priority-Based Flow Control Not Supported Commands Captive Portal Commands Supported cos-queue random-detect Supported no cos-queue random-detect Supported random-detect exponential Supported weighting-constant no random-detect exponential weighting-constant Supported random-detect queue-parms Supported no random-detect queue-parms Supported Require license Not Supported Supported Supported Not Supported Supported Supported Supported Supported Supported Supported Supported M5300-28G3 M5300-52G3 M5300-28GF3 Supported Not Supported Supported Supported Not Supported Supported Supported Supported Supported Supported Supported Supported GSM7328Sv2 GSM7352Sv2 Supported Not Supported Not Supported Supported Not Supported Supported Supported Supported Supported Supported Supported Supported GSM7228PS GSM7252PS Require license Supported Not Supported Supported Not Supported Supported Supported Supported Supported Supported Supported Supported Command Syntax A command is one or more words that might be followed by one or more parameters. Parameters can be required or optional values. Some commands, such as show network or clear vlan, do not require parameters. Other commands, such as network parms, require that you supply a value after the command. You must type the parameter values in a specific order, and optional parameters follow required parameters. The following example describes the network parms command syntax: Format network parms [gateway] • network parms is the command name. • and are parameters and represent required values that you must enter after you type the command keywords. Using the Command-Line Interface 10