Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 527

ProSafe Managed Switch show poe port info Use this command to get information about the status of the PoE ports. You can display information based on each individual port or all the ports collectively. The command displays only PSE-capable ports. Format Mode show poe port info [ |all] Privileged EXEC User EXEC Term Definition Intf Interface on which PoE is configured. Class Class of the powered device according to the IEEE802.3af and IEEE802.3at definition. Class Usage Max Power (watts) 0 Default 0.44-12.95 1 Optional 0.44-3.84 2 Optional 3.84-6.49 3 Optional 6.49-12.95 4 Optional 12.95-25.5 Power The power supplied to the powered device (in watts). Output The current supplied to the powered device (in mA). Current (mA) Output The voltage supplied to the powered device (in volts). Voltage (volts) Status The Status field reports the state of power supplied to the port. Possible values are: • Disabled-The PoE function is disabled on this port. • Searching-The port is detecting the PoE device. • Delivering Power-The port is providing power to the PoE device. • Fault-The POE device is not IEEE compliant; no power is provided. • Test-The port is in testing state. • Other Fault-The port has experienced problems other than compliance issues. When a port begins to deliver power, there is a trap indicating so. When a port stops delivering power, there is a trap indicating so. Example: (switch) #show poe port info all High Intf Power 1/0/1 Yes Max Output Power Class Power Current (W) (W) (mA) 32.0 Unknown 00.000 0 Output Voltage (volt) ------- 00.00 Status Fault Status Searching No Error (Switch) #show poe port info 1/0/33 High Max Output Output Power over Ethernet (PoE) Commands 527