Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 185

ProSafe Managed Switch no set mld mrouter interface Use this command to disable the status of the interface as a statically configured multicast router-attached interface. Format Mode no set mld mrouter interface Interface Config show mldsnooping Use this command to display MLD Snooping information. Configured information is displayed whether or not MLD Snooping is enabled. Format Mode show mldsnooping [unit/slot/port | vlanid] Privileged EXEC When the optional arguments unit/slot/port or vlanid are not used, the command displays the following information. Term Definition Admin Mode Indicates whether or not MLD Snooping is active on the switch. Interfaces Enabled for Interfaces on which MLD Snooping is enabled. MLD Snooping MLD Control Frame Count Displays the number of MLD Control frames that are processed by the CPU. VLANs Enabled for MLD VLANs on which MLD Snooping is enabled. Snooping When you specify the unit/slot/port values, the following information displays. Term Definition MLD Snooping Indicates whether MLD Snooping is active on the interface. Admin Mode Fast Leave Mode Indicates whether MLD Snooping Fast Leave is active on the VLAN. Group Membership Interval Shows the amount of time in seconds that a switch will wait for a report from a particular group on a particular interface, which is participating in the VLAN, before deleting the interface from the entry. This value may be configured. Max Response Time Displays the amount of time the switch waits after it sends a query on an interface, participating in the VLAN, because it did not receive a report for a particular group on that interface. This value may be configured. Multicast Router Present Expiration Time Displays the amount of time to wait before removing an interface that is participating in the VLAN from the list of interfaces with multicast routers attached. The interface is removed if a query is not received. This value may be configured. Switching Commands 185