Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 580

ProSafe Managed Switch client-identifier This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client identifier is required instead of hardware addresses. The unique-identifier is a concatenation of the media type and the MAC address. For example, the Microsoft client identifier for Ethernet address c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet media type. For more information, refer to the "Address Resolution Protocol Parameters" section of RFC 1700, Assigned Numbers for a list of media type codes. Default Format Mode none client-identifier DHCP Pool Config no client-identifier This command deletes the client identifier. Format Mode no client-identifier DHCP Pool Config client-name This command specifies the name for a DHCP client. Name is a string consisting of standard ASCII characters. Default Format Mode none client-name DHCP Pool Config no client-name This command removes the client name. Format Mode no client-name DHCP Pool Config default-router This command specifies the default router list for a DHCP client. {address1, address2... address8} are valid IP addresses, each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid. Default none Utility Commands 580