Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 691
snmp trap link-status all, show snmpcommunity
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 691 highlights
ProSafe Managed Switch no snmp trap link-status Use this command to disable link status traps by interface. Note: This command is valid only when the Link Up/Down Flag is enabled. Format Mode no snmp trap link-status Interface Config snmp trap link-status all Use this command to enable link status traps for all interfaces. Note: This command is valid only when the Link Up/Down Flag is enabled. For more information, see snmp-server enable traps linkmode on page 687. Format Mode snmp trap link-status all Global Config no snmp trap link-status all Use this command to disable link status traps for all interfaces. Note: This command is valid only when the Link Up/Down Flag is enabled. For more information, see snmp-server enable traps linkmode on page 687. Format Mode no snmp trap link-status all Global Config show snmpcommunity Use this command to display SNMP community information. Six communities are supported. You can add, change, or delete communities. The switch does not have to be reset for changes to take effect. Management Commands 691