Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 452

ProSafe Managed Switch show ipv6 mld groups Use this command to display information about multicast groups that MLD reported. The information is displayed only when MLD is enabled on at least one interface. If MLD was not enabled on even one interface, there is no group information to be displayed. Format Mode show ipv6 mld groups { | } • Privileged EXEC • User EXEC The following fields are displayed as a table when is specified. Field Description Group Address The address of the multicast group. Interface Interface through which the multicast group is reachable. Up Time Time elapsed in hours, minutes, and seconds since the multicast group has been known. Expiry Time Time left in hours, minutes, and seconds before the entry is removed from the MLD membership table. When is specified, the following fields are displayed for each multicast group and each interface. Field Description Interface Interface through which the multicast group is reachable. Group Address The address of the multicast group. Last Reporter The IP Address of the source of the last membership report received for this multicast group address on that interface. Filter Mode The filter mode of the multicast group on this interface. The values it can take are include and exclude. Version 1 Host Timer The time remaining until the router assumes there are no longer any MLD version-1 Hosts on the specified interface. Group Compat Mode The compatibility mode of the multicast group on this interface. The values it can take are MLDv1 and MLDv2. The following table is displayed to indicate all the sources associated with this group. Field Description Source Address The IP address of the source. Uptime Time elapsed in hours, minutes, and seconds since the source has been known. Expiry Time Time left in hours, minutes, and seconds before the entry is removed. IPv6 Multicast Commands 452