Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 522
poe priority, poe reset, no poe power management
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 522 highlights
ProSafe Managed Switch Dynamic Power Management Available power = 300 watts - 3 watts = 297 watts Format Mode Default poe power management {|all} {dynamic | static} Global Config dynamic no poe power management Use this command to set the power management mode to the default. Format Mode no poe power management {|all} Global Config poe priority Use this command to configure the priority on a specific port. This is used for power management purposes. The switch might not be able to supply power to all connected devices, so the port priority is used to determine which ports will supply power if adequate power capacity is not available for all enabled ports. For ports that have the same priority level, the lower numbered port will have higher priority. There are three options: • Crit-Critical priority • High-High priority • Low-Low priority Format Mode Default poe priority { Crit | High | Low } Global Config Interface Config low no poe priority Use this command to set the priority to the default. Format Mode no poe priority Global Config Interface Config poe reset Use this command to reset the PoE state of every port (in global mode) or a specific port (in interface mode). When the PoE port status is shown to be in an error state, this command can be Power over Ethernet (PoE) Commands 522