Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 206

ProSafe Managed Switch lldp med transmit-tlv all Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs). Default Format Mode By default, the capabilities and network policy TLVs are included. lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory] [location] [network-policy] Global Config Term capabilities ex-pd ex-pse inventory location network-policy Definition Transmit the LLDP capabilities TLV. Transmit the LLDP extended PD TLV. Transmit the LLDP extended PSE TLV. Transmit the LLDP inventory TLV. Transmit the LLDP location TLV. Transmit the LLDP network policy TLV. no lldp med transmit-tlv Use this command to remove a TLV. Format Mode no lldp med transmit-tlv all [capabilities] [network-policy] [ex-pse] [ex-pd] [location] [inventory] Global Config show lldp med Use this command to display a summary of the current LLDP MED configuration. Format Mode show lldp med Privileged Exec Term Fast Start Repeat Count Device Class Definition The number of LLDP PDUs that will be transmitted when the protocol is enabled. The local device's MED Classification. There are four different kinds of devices, three of them represent the actual end points (classified as Class I Generic[IP Communication Controller etc.], Class II Media Conference Bridge etc.], Class III Communication [IP Telephone etc.]. Class IV Network Connectivity Device, which is typically a LAN Switch, Router, IEEE 802.11 Wireless Access Point, etc. Switching Commands 206