Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 141
Static MAC Filtering, show monitor session, macfilter
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
ProSafe Managed Switch show monitor session This command displays the Port monitoring information for a particular mirroring session. Note: The parameter is an integer value used to identify the session. In the current version of the software, the parameter is always one (1) Format Mode show monitor session Privileged EXEC Term Session ID Admin Mode Probe Port Mirrored Port Type Definition An integer value used to identify the session. Its value can be anything between 1 and the maximum number of mirroring sessions allowed on the platform. Indicates whether the Port Mirroring feature is enabled or disabled for the session identified with . The possible values are Enabled and Disabled. Probe port (destination port) for the session identified with . If probe port is not set then this field is blank. The port, which is configured as mirrored port (source port) for the session identified with . If no source port is configured for the session then this field is blank. Direction in which source port configured for port mirroring. Types are tx for transmitted packets and rx for receiving packets. Static MAC Filtering The commands in this section describe how to configure static MAC filtering. Static MAC filtering allows you to configure destination ports for a static multicast MAC filter irrespective of the platform. macfilter This command adds a static MAC filter entry for the MAC address on the VLAN . The value of the parameter is a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF. The parameter must identify a valid VLAN. The number of static mac filters supported on the system is different for MAC filters where source ports are configured and MAC filters where destination ports are configured. • For unicast MAC address filters and multicast MAC address filters with source port lists, the maximum number of static MAC filters supported is 20. Switching Commands 141