Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 684

ProSafe Managed Switch snmp-server community Use this command to add (and name) a new SNMP community. A community is a name associated with the switch and with a set of SNMP managers that manage it with a specified privileged level. The length of can be up to 16 case-sensitive characters. Note: Community names in the SNMP Community Table must be unique. When making multiple entries using the same community name, the first entry is kept and processed and all duplicate entries are ignored. Default Format Mode • Public and private, which you can rename. • Default values for the remaining four community names are blank. snmp-server community Global Config no snmp-server community Use this command to remove this community name from the table. The is the community name to be deleted. Format Mode no snmp-server community Global Config snmp-server community ipaddr Use this command to set a client IP address for an SNMP community. The address is the associated community SNMP packet sending address and is used along with the client IP mask value to denote a range of IP addresses from which SNMP clients may use that community to access the device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is ANDed with the mask to determine the range of allowed client IP addresses. The name is the applicable community name. Default Format Mode 0.0.0.0 snmp-server community ipaddr Global Config Management Commands 684