Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 443
ipv6 pim hello-interval, show ipv6 pim
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 443 highlights
ProSafe Managed Switch ipv6 pim hello-interval Use this command to configure the PIM hello interval for the specified router interface. The hello-interval is specified in seconds and is in the range 10-18000. Default Format Mode 30 ipv6 pim hello-interval Interface Config no ipv6 pim hello-interval Use this command to set the PIM hello interval to the default value. Format Mode no ipv6 pim hello-interval Interface Config show ipv6 pim Use this command to display PIM Global Configuration parameters and PIM interface status. Format Mode show ipv6 pim • Privileged EXEC • User EXEC Term Definition PIM Mode Configured mode of PIM protocol Data Threshold Rate Rate (in kbps) of SPT Threshold Register Rate-limit Rate (in kbps) of Register Threshold Interface Valid unit, slot, and port number separated by forward slashes Interface-Mode Indicates whether PIM-DM is enabled or disabled on this interface Operational-Status The current state of PIM-DM on this interface. Possible values are Operational or Non-Operational. Example: The following shows example CLI display output for the command. (Switch) #show ipv6 pim PIM Mode Dense Data Threshold Rate (Kbps 0 Register Rate-limit (Kbps 0 Interface Interface Mode Operational-Status 1/0/1 Enabled Non-Operational IPv6 Multicast Commands 443