Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 179

ProSafe Managed Switch no set igmp querier version Use this command to set the IGMP Querier version to its default value. Format Mode no set igmp querier version Global Config set igmp querier election participate Use this command to enable the Snooping Querier to participate in the Querier Election process when it discovers the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping Querier finds that the other Querier's source address is better (less) than the Snooping Querier's address, it stops sending periodic queries. If the Snooping Querier wins the election, then it will continue sending periodic queries. Default Format Mode disabled set igmp querier election participate VLAN Config no set igmp querier election participate Use this command to set the Snooping Querier not to participate in querier election but go into non-querier mode as soon as it discovers the presence of another querier in the same VLAN. Format Mode no set igmp querier election participate VLAN Config show igmpsnooping querier Use this command to display IGMP Snooping Querier information. Configured information is displayed whether or not IGMP Snooping Querier is enabled. Format Mode show igmpsnooping querier [{detail | vlan }] Privileged EXEC When the optional argument is not used, the command displays the following information. Field Admin Mode Admin Version Querier Address Description Indicates whether or not IGMP Snooping Querier is active on the switch. The version of IGMP that will be used while sending out the queries. The IP Address which will be used in the IPv4 header while sending out IGMP queries. It can be configured using the appropriate command. Switching Commands 179