Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 140
no monitor, no monitor session
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
ProSafe Managed Switch specify the interface to receive the monitored traffic. Use the mode parameter to enabled the administrative mode of the session. If enabled, the probe port monitors all the traffic received and transmitted on the physical monitored port. Format Mode monitor session {source interface [{rx | tx}] | destination interface | mode} Global Config no monitor session Use this command without optional parameters to remove the monitor session (port monitoring) designation from the source probe port, the destination monitored port and all VLANs. Once the port is removed from the VLAN, you must manually add the port to any desired VLANs. Use the source interface parameter or destination interface to remove the specified interface from the port monitoring session. Use the mode parameter to disable the administrative mode of the session Note: Since the current version of 7000 series software supports only one session, if you do not supply optional parameters, the behavior of this command is similar to the behavior of the no monitor command. Format Mode no monitor session [{source interface | destination interface | mode}] Global Config no monitor This command removes all the source ports and a destination port for the and restores the default value for mirroring session mode for all the configured sessions. Note: This is a stand-alone "no" command. This command does not have a "normal" form. Default Format Mode enabled no monitor Global Config Switching Commands 140