Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 218
dos-control tcpflagseq
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
ProSafe Managed Switch no dos-control udpport This command disables UDP L4 source = destination port number (Source UDP Port = Destination UDP Port) Denial of Service protection. Format Mode no dos-control udppport Global Config dos-control tcpflagseq This command enables TCP Flag and Sequence Denial of Service protections. If the mode is enabled, Denial of Service prevention is active for this type of attack. If packets ingress having TCP Flag SYN set and a source port less than 1024 or having TCP Control Flags set to 0 and TCP Sequence Number set to 0 or having TCP Flags FIN, URG, and PSH set and TCP Sequence Number set to 0 or having TCP Flags SYN and FIN both set, the packets will be dropped if the mode is enabled. Default Format Mode disabled dos-control tcpflagseq Global Config no dos-control tcpflagseq This command sets disables TCP Flag and Sequence Denial of Service protection. Format Mode no dos-control tcpflagseq Global Config dos-control tcpoffset This command enables TCP Offset Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for this type of attack. If packets ingress having TCP Header Offset equal to one (1), the packets will be dropped if the mode is enabled. Default Format Mode disabled dos-control tcpoffset Global Config no dos-control tcpoffset This command disabled TCP Offset Denial of Service protection. Format Mode no dos-control tcpoffset Global Config Switching Commands 218