Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 608

ProSafe Managed Switch neither keyword is used in the command, then all PIMSMv6 packet traces are dumped. Vital information such as source address, destination address, control packet type, packet length, and the interface on which the packet is received or transmitted is displayed on the console. Default Format Mode disabled debug ipv6 pimsm packet [receive|transmit] Privileged EXEC no debug ipv6 pimsm packet Use this command to disable debug tracing of PIMSMv6 packet reception and transmission. Format Mode no debug ipv6 pimsm packet [receive|transmit] Privileged EXEC debug lacp packet This command enables tracing of LACP packets received and transmitted by the switch. Default Format Mode disabled debug lacp packet Privileged EXEC A sample output of the trace message is shown below. JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %% Pkt TX - Intf: 1/0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key: 0x36 no debug lacp packet This command disables tracing of LACP packets. Format Mode no debug lacp packet Privileged EXEC debug mldsnooping packet Use this command to trace MLD snooping packet reception and transmission. receive traces only received MLD snooping packets and transmit traces only transmitted MLD snooping packets. When neither keyword is used in the command, then all MLD snooping packet traces are dumped. Vital information such as source address, destination address, control Utility Commands 608