Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 296

ProSafe Managed Switch no external-lsdb-limit This command configures the default external LSDB limit for OSPF. Format Mode no external-lsdb-limit Router OSPF Config log-adjacency-changes To enable logging of OSPFv2 neighbor state changes, use this command in router configuration mode. State changes are logged with INFORMATIONAL severity. Default Format Mode Adjacency state changes are logged, but without the detail option. log-adjacency-changes [detail] OSPFv2 Router Configuration Parameter detail Description (Optional) When this keyword is specified, all adjacency state changes are logged. Otherwise, OSPF only logs transitions to FULL state and when a backwards transition occurs. no log-adjacency-changes Use the no form of the command to disable state change logging. Format Mode no log-adjacency-changes [detail] OSPFv2 Router Configuration ip ospf authentication This command sets the OSPF Authentication Type and Key for the specified interface. The value of is either none, simple or encrypt. The is composed of standard displayable, non-control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8 bytes or less if the authentication type is simple. If the type is encrypt, the key may be up to 16 bytes. If the type is encrypt a in the range of 0 and 255 must be specified. Unauthenticated interfaces do not need an authentication key or authentication key ID. There is no default value for this command. Format Mode ip ospf authentication {none | {simple } | {encrypt }} Interface Config Routing Commands 296