Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 23
movemanagement, standby, Stacking Commands, ProSafe Managed Switch
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
ProSafe Managed Switch Note: If the management unit is renumbered, then the running configuration is no longer applied (that is, the stack acts as if the configuration had been cleared). Format Mode switch renumber Global Config movemanagement This command moves the Primary Management Unit functionality from one switch to another. The is the switch identifier on the current Primary Management Unit. The is the switch identifier on the new Primary Management Unit. Upon execution, the entire stack (including all interfaces in the stack) is unconfigured and reconfigured with the configuration on the new Primary Management Unit. After the reload is complete, all stack management capability must be performed on the new Primary Management Unit. To preserve the current configuration across a stack move, execute the copy system:running-config nvram:startup-config (in Privileged EXEC) command before performing the stack move. A stack move causes all routes and layer 2 addresses to be lost. This command is executed on the Primary Management Unit. The system prompts you to confirm the management move. Note: The movemanagement command does not NSF (non-stop forwarding). To move the management unit to the backup unit, use initiate failover instead. For more information, see initiate failover on page 33. Format Mode movemanagement Stack Global Config standby Use this command to configure a unit as a Standby Management Unit (STBY). Format Mode standby Stack Global Config Stacking Commands 23