Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 477
match source-address mac, match srcip, <ipaddr>, <ipmask>
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 477 highlights
ProSafe Managed Switch Note: This command does not validate the protocol number value against the current list defined by IANA. Default Format Mode none match protocol { | } Class-Map Config Ipv6-Class-Map Config match source-address mac This command adds to the specified class definition a match condition based on the source MAC address of a packet. The parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The parameter is a layer 2 MAC address bit mask, which may not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc). Default Format Mode none match source-address mac Class-Map Config Ipv6-Class-Map Config match srcip This command adds to the specified class definition a match condition based on the source IP address of a packet. The parameter specifies an IP address. The parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits. Default Format Mode none match srcip Class-Map Config match srcip6 This command adds to the specified class definition a match condition based on the source IP address of a packet. Default none Quality of Service (QoS) Commands 477