Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 275
router con d on a specific interface. Use the output of the command to verify the track
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 275 highlights
ProSafe Managed Switch show ip vrrp interface This command displays all configuration information and VRRP router statistics of a virtual router configured on a specific interface. Use the output of the command to verify the track interface and track IP route configurations. Format Modes show ip vrrp interface { } • Privileged EXEC • User EXEC Term Definition Primary IP Address The configured IP address for the Virtual router. VMAC address The VMAC address of the specified router. Authentication type The authentication type for the specific virtual router. Priority The priority value for the specific virtual router, taking into account any priority decrements for tracked interfaces or routes. Configured Priority The priority configured through the ip vrrp priority command. Advertisement interval The advertisement interval in seconds for the specific virtual router. Pre-Empt Mode The preemption mode configured on the specified virtual router. Administrative The status (Enable or Disable) of the specific router. Mode State The state (Master/backup) of the virtual router. The following shows example CLI display output for the command. (Switch)#show ip vrrp interface 1/0/1 1 Primary IP Address 1.1.1.5 VMAC Address 00:00:5e:00:01:01 Authentication Type None Priority 100 Configured priority 100 Advertisement Interval (secs 1 Pre-empt Mode Enable Administrative Mode Disable Accept Mode Enable State Initialized Track Interface State ------ DecrementPriority down 10 TrackRoute (pfx/len 10.10.10.1/255.255.255.0 State ------ down DecrementPriority 10 Routing Commands 275