Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 90
GARP Commands, show interface ethernet <unit/slot/port> switchport, set garp timer join
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
ProSafe Managed Switch show interface ethernet switchport This command displays the private-VLAN mapping information for the switch interfaces. Format Mode show interface ethernet switchport • Privileged EXEC • User EXEC Term Private-vlan host-association Private-vlan mapping Definition Displays VLAN association for the private-VLAN host ports. Displays VLAN mapping for the private-VLAN promiscuous ports GARP Commands This section describes the commands you use to configure Generic Attribute Registration Protocol (GARP) and view GARP status. The commands in this section affect both GARP VLAN Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP). GARP is a protocol that allows client stations to register with the switch for membership in VLANS (by using GVMP) or multicast groups (by using GVMP). set garp timer join This command sets the GVRP join time for one port (Interface Config mode) or all (Global Config mode) and per GARP. Join time is the interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or multicast group. This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds). The value 20 centiseconds is 0.2 seconds. Default Format Mode 20 set garp timer join • Interface Config • Global Config no set garp timer join This command sets the GVRP join time (for one or all ports and per GARP) to the default and only has an effect when GVRP is enabled. Format Mode no set garp timer join • Interface Config • Global Config Switching Commands 90