Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 222
MAC Database Commands, bridge aging-time
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
ProSafe Managed Switch Term Definition UDP Port Mode May be enabled or disabled. The factory default is disabled. SIPDIP Mode May be enabled or disabled. The factory default is disabled. SMACDMAC Mode May be enabled or disabled. The factory default is disabled. TCP Flag Mode May be enabled or disabled. The factory default is disabled. TCP FIN&URG& PSH Mode May be enabled or disabled. The factory default is disabled. TCP Flag & Sequence Mode May be enabled or disabled. The factory default is disabled. TCP SYN Mode May be enabled or disabled. The factory default is disabled. TCP SYN & FIN Mode May be enabled or disabled. The factory default is disabled. TCP Fragment Mode May be enabled or disabled. The factory default is disabled. TCP Offset Mode May be enabled or disabled. The factory default is disabled. MAC Database Commands This section describes the commands you use to configure and view information about the MAC databases. bridge aging-time This command configures the forwarding database address aging timeout in seconds. The parameter must be within the range of 10 to 1,000,000 seconds. Default Format Mode 300 bridge aging-time Global Config no bridge aging-time This command sets the forwarding database address aging timeout to the default value. Format Mode no bridge aging-time Global Config Switching Commands 222