Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 336

ProSafe Managed Switch Term RIP Mode Link State Definition The administrative mode of router RIP operation (enabled or disabled). The mode of the interface (up or down). show ip rip interface This command displays information related to a particular RIP interface. Format Modes show ip rip interface { | vlan } • Privileged EXEC • User EXEC Term Definition Interface Valid slot and port number separated by forward slashes. This is a configured value. IP Address The IP source address used by the specified RIP interface. This is a configured value. Send Version The RIP version(s) used when sending updates on the specified interface. The types are none, RIP-1, RIP-1c, RIP-2. This is a configured value. Receive Version The RIP version(s) allowed when receiving updates from the specified interface. The types are none, RIP-1, RIP-2, Both. This is a configured value. RIP Admin Mode RIP administrative mode of router RIP operation; enable activates, disable de-activates it. This is a configured value. Link State Indicates whether the RIP interface is up or down. This is a configured value. Authentication The RIP Authentication Type for the specified interface. The types are none, simple, and Type encrypt. This is a configured value. Default Metric A number which represents the metric used for default routes in RIP updates originated on the specified interface. This is a configured value. The following information will be invalid if the link state is down. Term Bad Packets Received Bad Routes Received Updates Sent Definition The number of RIP response packets received by the RIP process which were subsequently discarded for any reason. The number of routes contained in valid RIP packets that were ignored for any reason. The number of triggered RIP updates actually sent on this interface. ICMP Throttling Commands This section describes the commands you use to configure options for the transmission of various types of ICMP messages. Routing Commands 336