Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 256

ProSafe Managed Switch show ip interface brief This command displays summary information about IP configuration settings for all ports in the router. Format Modes show ip interface brief • Privileged EXEC • User EXEC Term Interface State IP Address IP Mask Netdir Bcast MultiCast Fwd Method Definition Valid slot and port number separated by forward slashes. Routing operational state of the interface. The IP address of the routing interface in 32-bit dotted decimal format. The IP mask of the routing interface in 32-bit dotted decimal format. Indicates if IP forwards net-directed broadcasts on this interface. Possible values are Enable or Disable. The multicast forwarding administrative mode on the interface. Possible values are Enable or Disable. Shows whether the IP address was configured manually or acquired from a DHCP server. show ip protocols This command lists a summary of the configuration and status for each unicast routing protocol. The command lists routing protocols that are configured and enabled. If a protocol is selected on the command line, the display is limited to that protocol. Format Mode show ip protocols [ospf | rip] Privileged EXEC Parameter Description OSPFv2 Router ID The router ID configured for OSPFv2 OSPF Admin Mode Whether OSPF is enabled or disabled globally Maximum Paths The maximum number of next hops in an OSPF route Routing for Networks The address ranges configured with an OSPF network command Distance The administrative distance (or route preference) for intra-area, inter-area, and external routes Default Route Advertise Whether OSPF is configured to originate a default route Routing Commands 256