Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 582
lease, network DHCP Pool Config, infinite, Hours, Minutes
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 582 highlights
ProSafe Managed Switch host This command specifies the IP address and network mask for a manual binding to a DHCP client. Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0 to 32. Default Format Mode none host [{ | }] DHCP Pool Config no host This command removes the IP address of the DHCP client. Format Mode no host DHCP Pool Config lease This command configures the duration of the lease for an IP address that is assigned from a DHCP server to a DHCP client. The overall lease time should be between 1-86400 minutes. If you specify infinite, the lease is set for 60 days. You can also specify a lease duration. Days is an integer from 0 to 59. Hours is an integer from 0 to 23. Minutes is an integer from 0 to 59. Default Format Mode 1 (day) lease [{ [] [] | infinite}] DHCP Pool Config no lease This command restores the default value of the lease time for DHCP Server. Format Mode no lease DHCP Pool Config network (DHCP Pool Config) Use this command to configure the subnet number and mask for a DHCP address pool on the server. Network-number is a valid IP address, made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified address pool. The prefix-length is an integer from 0 to 32. Default none Utility Commands 582