Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 374
no interface tunnel, tunnel source, tunnel destination, tunnel mode ipv6ip
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 374 highlights
ProSafe Managed Switch tunnel from the destination address of packets routed into the tunnel. To assign an IP address to the tunnel interface, see ip address on page 247. To assign an IPv6 address to the tunnel interface, see ipv6 address on page 377. interface tunnel Use this command to enter the Interface Config mode for a tunnel interface. The range is 0 to 7. Format Mode interface tunnel Global Config no interface tunnel This command removes the tunnel interface and associated configuration parameters for the specified tunnel interface. Format Mode no interface tunnel Global Config tunnel source This command specifies the source transport address of the tunnel, either explicitly or by reference to an interface. Format Mode tunnel source { | ethernet } Interface Config tunnel destination This command specifies the destination transport address of the tunnel. Format Mode tunnel destination {} Interface Config tunnel mode ipv6ip This command specifies the mode of the tunnel. With the optional 6to4 argument, the tunnel mode is set to 6to4 automatic. Without the optional 6to4 argument, the tunnel mode is configured. Format Mode tunnel mode ipv6ip [6to4] Interface Config IPv6 Commands 374