Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 341

ProSafe Managed Switch no ip multicast ttl-threshold This command applies the default to a routing interface. The is the TTL threshold which is to be applied to the multicast Data packets which are to be forwarded from the interface. Format Mode no ip multicast ttl-threshold Interface Config ip mroute This command configures an IPv4 Multicast Static Route for a Source. src-addr is Source IP address of a multicast source or source IP route prefix. src-mask is Mask associated with the source IP address or source IP route prefix. rpf-addr is IP address to be used as the RPF address. The interface associated with this IP address, thus, is used as the incoming interface for the mroute. preference is Administrative distance for the mroute. The lower values have better preference. If the static mroute has the same distance as the other RPF sources, the static mroute will take precedence. The range is from 0 to 255. The default is 0 . Default Format Mode No MRoute is configured on the system ip mroute Global Config no ip mroute This command removes the configured IP Multicast Static Route. Format Mode noip mroute Global Config show ip mcast This command displays the system-wide multicast information. Format Modes show ip mcast • Privileged EXEC • User EXEC Term Admin Mode Protocol State Definition The administrative status of multicast. Possible values are enabled or disabled. The current state of the multicast protocol. Possible values are Operational or Non-Operational. IP Multicast Commands 341