Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 550

ProSafe Managed Switch of lines. The command terminal length 0 disables pagination and, as a result, the output of the show running-config command is displayed immediately. Default Format Mode 24 lines per page terminal length Privileged EXEC no terminal length Use this command to set the terminal length to the default value. Format Mode no terminal length Privileged EXEC show terminal length Use this command to display the value of the user-configured terminal length size. Format Mode show terminal length Privileged EXEC memory free low-watermark processor Use this command to get notifications when the CPU free memory falls below the configured threshold. A notification is generated when the free memory falls below the threshold. Another notification is generated once the available free memory rises to 10 percent above the specified threshold. To prevent generation of excessive notifications when the CPU free memory fluctuates around the configured threshold, only one Rising or Falling memory notification is generated over a period of 60 seconds. The threshold is specified in kilobytes. The CPU free memory threshold configuration is saved across a switch reboot. Format Mode memory free low-watermark processor Global Config Parameter low-watermark Description When CPU free memory falls below this threshold, a notification message is triggered. The range is 1 to the maximum available memory on the switch. The default is 0 (disabled). Logging Commands This section describes the commands you use to configure system logging, and to view logs and the logging settings. Utility Commands 550