Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 741
Table 49., IGMP-Proxy Log Messages, Table 50., PIM-SM Log Messages
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 741 highlights
ProSafe Managed Switch Table 49. IGMP-Proxy Log Messages Component IGMP-Proxy IGMP-Proxy Message Cause Error getting memory for igmp host group record When we are unable to allocate memory for the IGMP group record in the Host (Proxy) table Error getting memory for source record When we are unable to allocate memory for the IGMP source record in the Host (Proxy) table Table 50. PIM-SM Log Messages Component PIM-SM PIM-SM PIM-SM PIM-SM PIM_SM PIM-SM Message Cause PIM-SM not initialized This message arises when trying to activate pimsm interfaces or receiving pimsm packets when pimsm component is not initialized. Unable to take xxx semaphore This message is logged when failed to acquire semaphore to access source list or group list or candidate Rp list or virtual interface list. The xxx specifies the list for which the access is denied. Warning : Could not send packet type xxx (pimsm packet type) on rtrIfNum this warning is logged when failed to send a pimsm control packet on the specified router interface. add_kernel_cache : memory allocation failed This message is logged when there is insufficient memory to add an mroute entry into cache. Config error. Trying to add static RP. Dynamic RP with same ip addr exists Router learns RP-group mapping through Bootstrap messages received.This message pops when the static RP is configured which conflicts the mapping learnt dynamically through Bootstrap messages. Inner xxx(source/group) address of register This log message appears when a register message is invalid message is received with invalid inner ip source or group address. Log Messages 741