Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 351

ProSafe Managed Switch no ip pim hello-interval This command resets the transmission frequency of hello messages between PIM enabled neighbors to its default value. Format Mode no ip pim hello-interval Interface Config show ip pim interface This command displays the PIM Interface status parameters. If the interface number is not specified, this command displays the status parameters of all the PIM enabled interfaces. Format Modes show ip pim interface Privileged EXEC Term Definition Mode Active PIM protocol Interface Interface number. Hello Interval Hello interval value. The frequency at which PIM hello messages are transmitted on this interface. By default, the value is 30 seconds. Join-prune Interval Join-prune interval value. DR Priority DR Priority configured on this Interface. This is not applicable if the interface mode is Dense BSR Border Is this interface configured as a BSR Border? Neighbor Count Number of PIM Neighbors learnt on this interface. This field is displayed only when the interface is operational. Designated -Router IP Address of the elected DR on the Interface. This field is displayed only when the interface is Operational. Example 1: (Switch) #show ip pim interface Interface 1/0/1 Mode Sparse Hello Interval (secs) 30 Join Prune Interval (secs) 60 DR Priority 1 BSR Border Disabled Neighbor Count 1 Designated Router 192.168.10.1 Example 2: (Switch) #show ip pim interface Interface 1/0/1 Mode Dense Hello Interval (secs) 30 IP Multicast Commands 351