Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 735

ProSafe Managed Switch Table 32. 802.1Q Log Messages Component 802.1Q 802.1Q 802.1Q 802.1Q 802.1Q Message Cause dot1qIssueCmd: Unable to send message dot1qMsgQueue is full. %d to dot1qMsgQueue for vlan %d - %d msgs in queue dot1qVlanCreateProcess: Attempt to create a vlan with an invalid vlan id %d ; VLAN %d not in range, This accommodates for reserved vlan ids. i.e. 4094 - x dot1qMapIntfIsConfigurable: Error accessing DOT1Q config data for interface %d in dot1qMapIntfIsConfigurable. A default configuration does not exist for this interface. Typically a case when a new interface is created and has no pre-configuration. dot1qVlanDeleteProcess: Deleting the default VLAN Typically encountered during clear Vlan and clear config dot1qVlanMemberSetModify, dot1qVlanTaggedMemberSetModify: Dynamic entry %d can only be modified after it is converted to static If this vlan is a learnt via GVRP then we cannot modify it's member set via management. Table 33. 802.1S Log Messages Component 802.1S 802.1S 802.1S Message Cause dot1sIssueCmd: Dot1s Msg Queue is full!!!!Event: %u, on interface: %u, for instance: %u The message Queue is full. dot1sStateMachineRxBpdu(): Rcvd BPDU Discarded The current conditions, like port is not enabled or we are currently not finished processing another BPDU on the same interface, does not allow us to process this BPDU dot1sBpduTransmit(): could not get a buffer Out of system buffers Table 34. Port Mac Locking Log Message Component Port Mac Locking Message Cause pmlMapIntfIsConfigurable: Error accessing PML config data for interface %d in pmlMapIntfIsConfigurable. A default configuration does not exist for this interface. Typically a case when a new interface is created and has no pre-configuration. Log Messages 735