Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 241

ProSafe Managed Switch arp This command creates an ARP entry. The value for is the IP address of a device on a subnet attached to an existing routing interface. is a unicast MAC address for that device. The format of the MAC address is 6 two-digit hexadecimal numbers that are separated by colons, for example 00:06:29:32:81:40. Format Mode arp Global Config no arp This command deletes an ARP entry. The value for is the IP address of the interface. The value for is the IP address of a device on a subnet attached to an existing routing interface. is a unicast MAC address for that device. Format Mode no arp Global Config ip local-proxy-arp This command enables local-proxy-arp on interface or range of interfaces. The switch only responds if all next hops in its route to the destination are through interfaces other than the interface that received the ARP request. Enabling local proxy ARP removes this restriction.. Default Format Mode disabled ip local-proxy-arp Interface Config no ip local-proxy-arp This command disables local-proxy-arp on the interface or a range of interfaces. Format Mode no ip local-proxy-arp Interface Config ip proxy-arp This command enables proxy ARP on a router interface. Without proxy ARP, a device only responds to an ARP request if the target IP address is an address configured on the interface where the ARP request arrived. With proxy ARP, the device may also respond if the target IP Routing Commands 241