Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 331
default-metric RIP, distance rip, distribute-list out RIP
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 331 highlights
ProSafe Managed Switch default-metric (RIP) This command is used to set a default for the metric of distributed routes. Format Mode default-metric Router RIP Config no default-metric (RIP) This command is used to reset the default metric of distributed routes to its default value. Format Mode no default-metric Router RIP Config distance rip This command sets the route preference value of RIP in the router. Lower route preference values are preferred when determining the best route. A route with a preference of 255 cannot be used to forward traffic. Default Format Mode 15 distance rip Router RIP Config no distance rip This command sets the default route preference value of RIP in the router. Format Mode no distance rip Router RIP Config distribute-list out (RIP) This command is used to specify the access list to filter routes received from the source protocol. Default Format Mode 0 distribute-list out {ospf | static | connected} Router RIP Config Routing Commands 331