Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 249
release dhcp, renew dhcp, show dhcp lease, Format, IP address, Subnet mask, DHCP Lease, server, State
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 249 highlights
ProSafe Managed Switch release dhcp Use this command to force the DHCPv4 client to release the leased address from the specified interface. Format Mode release dhcp Privileged EXEC renew dhcp Use this command to force the DHCPv4 client to immediately renew an IPv4 address lease on the specified interface. Format Mode renew dhcp {|network-port} Privileged EXEC Note: This command can be used on in-band ports as well as network (out-of-band) port. show dhcp lease Use this command to display a list of IPv4 addresses currently leased from a DHCP server on a specific in-band interface or all in-band interfaces. This command does not apply to service or network ports. Format Mode show dhcp lease [interface ] Privileged EXEC Term Definition IP address, Subnet mask The IP address and network mask leased from the DHCP server. DHCP Lease server The IPv4 address of the DHCP server that leased the address. State State of the DHCPv4 Client on this interface. DHCP transaction ID The transaction ID of the DHCPv4 Client. Lease The time (in seconds) that the IP address was leased by the server. Renewal The time (in seconds) when the next DHCP renew Request is sent by DHCPv4 Client to renew the leased IP address. Rebind The time (in seconds) when the DHCP Rebind process starts. Retry count Number of times the DHCPv4 client sends a DHCP REQUEST message before the server responds. Routing Commands 249