Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 479

ProSafe Managed Switch DiffServ Policy Commands Use the DiffServ policy commands to specify traffic conditioning actions, such as policing and marking, to apply to traffic classes Use the policy commands to associate a traffic class that you define by using the class command set with one or more QoS policy attributes. Assign the class/policy association to an interface to form a service. Specify the policy name when you create the policy. Each traffic class defines a particular treatment for packets that match the class definition. You can associate multiple traffic classes with a single policy. When a packet satisfies the conditions of more than one class, preference is based on the order in which you add the classes to the policy. The first class you add has the highest precedence. This set of commands consists of policy creation/deletion, class addition/removal, and individual policy attributes. Note: The only way to remove an individual policy attribute from a class instance within a policy is to remove the class instance and re-add it to the policy. The values associated with an existing policy attribute can be changed without removing the class instance. The CLI command root is policy-map. assign-queue This command modifies the queue id to which the associated traffic stream is assigned. The queueid is an integer from 0 to n-1, where n is the number of egress queues supported by the device. Format Mode Incompatibilities assign-queue Policy-Class-Map Config Drop drop This command specifies that all packets for the associated traffic stream are to be dropped at ingress. Format Mode Incompatibilities drop Policy-Class-Map Config Assign Queue, Mark (all forms), Mirror, Police, Redirect Quality of Service (QoS) Commands 479