Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 300
ip ospf transmit-delay, ip ospf mtu-ignore
View all Netgear M5300-52G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 300 highlights
ProSafe Managed Switch no ip ospf retransmit-interval This command sets the default OSPF retransmit Interval for the specified interface. Format Mode no ip ospf retransmit-interval Interface Config ip ospf transmit-delay This command sets the OSPF Transit Delay for the specified interface. The transmit delay is specified in seconds. In addition, it sets the estimated number of seconds it takes to transmit a link state update packet over this interface. Valid values for range from 1 to 3600 (1 hour). Default Format Mode 1 ip ospf transmit-delay Interface Config no ip ospf transmit-delay This command sets the default OSPF Transit Delay for the specified interface. Format Mode no ip ospf transmit-delay Interface Config ip ospf mtu-ignore This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF Database Description packets specify the size of the largest IP packet that can be sent without fragmentation on the interface. When a router receives a Database Description packet, it examines the MTU advertised by the neighbor. By default, if the MTU is larger than the router can accept, the Database Description packet is rejected and the OSPF adjacency is not established. Default Format Mode enabled ip ospf mtu-ignore Interface Config no ip ospf mtu-ignore This command enables the OSPF MTU mismatch detection. Format Mode no ip ospf mtu-ignore Interface Config Routing Commands 300