Netgear M5300-52G3 Command Line Interface (CLI) User Manual - Page 505

ProSafe Managed Switch no ipv6 traffic-filter This command removes an IPv6 ACL identified by from the interface(s) in a given direction. Format Modes no ipv6 traffic-filter {{control-plane|in|out}|vlan {in|out}} • Global Config • Interface Config show ipv6 access-lists This command displays an IPv6 access list and all of the rules that are defined for the IPv6 ACL. Use the [name] parameter to identify a specific IPv6 ACL to display. Format Mode show ipv6 access-lists [name] Privileged EXEC Term Definition Rule Number The ordered rule number identifier defined within the IPv6 ACL. Action The action associated with each rule. The possible values are Permit or Deny. Match All Indicates whether this access list applies to every packet. Possible values are True or False. Protocol The protocol to filter for this rule. Source IP Address The source IP address for this rule. Source L4 Port Keyword The source port for this rule. Destination IP The destination IP address for this rule. Address Destination L4 The destination port for this rule. Port Keyword IP DSCP The value specified for IP DSCP. Flow Label The value specified for IPv6 Flow Label. Log Displays when you enable logging for the rule. Assign Queue The queue identifier to which packets matching this rule are assigned. Mirror Interface The unit/slot/port to which packets matching this rule are copied. Redirect Interface The unit/slot/port to which packets matching this rule are forwarded. Time Range Name Displays the name of the time-range if the IPv6 ACL rule has referenced a time range. Rule Status Status(Active/Inactive) of the IPv6 ACL rule. Quality of Service (QoS) Commands 505