Ricoh 3045 User Instructions - Page 83
Stamp, Transmission Options
View all Ricoh 3045 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Sub Transmission Mode Stamp The optional ADF is required. ❒ A paper jam during Parallel Memory Transmission may cause the transmission to fail even if stamping is performed. When sending a fax document using the ADF, the machine can stamp a circle mark at the bottom of the original. ❒ You cannot turn the Stamp function on or off while an original is being scanned. When sending a two-sided document, the document is marked at the bottom of the front page and top of the rear A Place the original, and then select the scan settings you require. page. This stamp indicates that the Reference original has been successfully stored in memory for Memory Transmission, or successfully sent by Immediate Transmission. p.15 "Placing Originals", Fac- simile Reference p.34 "Scan Settings", Facsimile 4 Reference B Press [Sub TX Mode]. Note ❒ Stamp only works when scanning from the ADF. ❒ When the stamp starts getting lighter, replace the cartridge. See "Replacing the Stamp Cartridge", General Settings Guide. ❒ If a page was not stamped even though the Stamp function is turned on, you need to resend that page. ❒ If you use this function often, you can set the default in General Settings and Adjustment so that this function is always on. In this case, Stamp can easily be turned off for any single transmission by pressing [Stamp]. See p.145 "General Settings/Adjustment". C Press [Stamp], and then press [OK]. Note ❒ To cancel the stamp, press [Stamp] again before pressing [OK]. D Specify the destination, and then press the {Start} key. Transmission Options This section describes various functions that you can switch on and off for any particular transmission, following the procedures given here. In addition, if you frequently use a certain option configuration, you can change the default home position (on or off) of each option. 73